Hi,
Thanks for your reply.
My goal is to understand where and when the Vcni subnets must be created and when then Dvfilter de-encapsulate the Vcni ID.
Now I have an Org Network with Vlan Tag 30 and a subnet 10.0.30.0 /24 so I have a 1% of network pool consumed (in my network pools there are 100 network so one subnet mean 1%). I've created the network pool and the Dvswitch correctly has associate the Vlan 30.
Now my question is: to create new subnets like 192.168.5.0,192.168.10.0 etc etc... What do I do? and in this scenario I can ping the switch gateway 10.0.30.254 (the Vlan number 30 address on the switch)? I can do with NAT the 192.168... address?
I understand that the "APARTMENT" like you said reduce one by one and I know that the purpose of the networks are different but is the same create a subnet in Org or in the Vapp from the VCNI point of view?
I also cannot ping between my VM under the ORG NETWORK and my physical switch (HP PROCURVE V1910)..i increase the MTU to 1600 in the Vcenter and in the network pool but in the switch i can't see any section to increase them...The MAC address of the VM however is learned in the ARP table of the switch meaning that some information arrive to the switch..
In last request my goal is to ping the switch with VCNI pool networks..
If you could give me some advice to design correctly I must appreciate your point of view..
Thanks
Giovanni